* Zadig reports 0 devices in normal mode. I forgot whatever arcane hax I performed on the device to make it work. * It used to work at some point when I upgraded stock FW. * Uninstalled FrSky Taranic Radio USB Device from under Device Manager->Disk Devices. Device is recognized by Windows ( ), but not DFU. * Perofmed all applicable steps while entering X-lite bootloader using trim+power. * Replaced USB driver using zadig with libusbK. * Replaced USB driver using zadig with libusb. * Replaced USB driver using zadig with winusb. dfu-util -l still does not list any devices.
* Replaced DFU install embedded in opentx, 0.7 default with 0.9. Windows sees SD card, but device not detected by DFU. * Booted in normal mode, connected as SD card. Windows sees joystick ( ), but device not detected by DFU. * Booted in normal mode, connected as Joystick. * Connected to USB 2.0 port, device is detected via USB, but DFU fails. * Connected to USB 3.0 port, device is detected via USB, but DFU fails. ( ) Cannot read model data, cannot read firmware. I'm so frustrated! How did it work perfectly yesterday but will not work today?! Has anyone else experienced this problem before? Any ideas what I need to do differently? Companion continues to say "No Radio was Found". When I go to "Devices and Printers" I see it labeled as "FrSky Taranis Bootloader" but it does not show up in "My Computer" anymore and is not recognized by Companion.
I tried re-installing both versions of Companion as well as the drivers with no success. I "Rolled Back" the driver under "Devices and Printers". Now this radio is not found either! I tried uninstalling both versions of Companion as well as the drivers. I thought that maybe there was a problem with this radio so I plugged in the one I updated yesterday. This time, the radio does not show up in "My Computer" and is not found in Companion 2.1 or Companion 2.0. Today I went to update my next Taranis X9D Plus which I use for work, same exact radio.
When I plugged the radio in, I was able to see it in "My Computer" under "Devices with Removable Storage". I even updated the sounds to the "Amber" sounds. I updated it following a YouTube tutorial and everything went perfectly. So yesterday I updated the firmware on my radio to 2.1.9 from 2.0.X (I don't remember which version is was). Hi everyone, this is my first post in this forum! I'm having trouble updating firmware on a FrSky Taranis X9D Plus and something very strange is happening.